DuraLabel 9000 Guide de l'utilisateur télécharger pdf (Page 27)

A. Gap Mode

Press the or to move the cursor to the media type and press

to enter the sensor calibration mode.

Note: If printing from enclosed software/driver, the software/driver will send out

the GAP or BLINE command, which will overwrite the sensor type setting

set from the front panel.

A-1 Automatic

When you enter the [Automatic] option, you will see following message, and

the printer will feed 2 to 3 gap labels to calibrate the sensor sensitivity

automatically. When calibration is completed, the LCD screen will return to

the previous menu.

A-2 Manual

If “Automatic” sensor calibration is unable to adjust the supply, please use

“Manual” function to calibrate the gap sensor manually.

When you enter the [Manual] option, you will see following message. Please

complete these steps:

Paper Len.

00812 dot

1. Press to move the cursor

from left digit to right digit, and press

to set the value from “0” to “9”

and the “dot/ mm/ inch”. Press

to set the paper length into

the printer.

Calibration 1/4

> Gap Mode

Bline Mode

Cont. Mode

Gap Mode 1/4

> Automatic

Manual

Pre-Printed

Gap Mode

Automatic

Gap Mode 2/4

Automatic

> Manual

Pre-Printed

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 52 53

Pas de commentaire

DuraLabel 9000 Guide de l'utilisateur Page 27